Skip to main content

Be The First To Review This Product!

Help other Buyerwish users shop smarter by writing reviews for products you have purchased.

Write a product review

EasyWood is a wood-filled PLA-based filament which is gravimetrically filled with approximately 40% grinded wood particles. EasyWood is a very easy to print wood filament as it is based on our EasyFil PLA compound and the 40% gravimetrical filling with grinded wood particles make the filament absolutely warp-free.

EasyWood looks, feels and smells like real wood and beautiful wood-nerve structures can be obtained by grinding the printed object a bit with a piece of fine grit sandpaper or by varying with the printing temperature.

Unique features

  • Extremely high wood-filling of 40%
    • Real wood feel, look and smell
  • Very easy to print
    • Warp-free printing and no deformation after cooling
    • Great thermal stability and filament flowing behaviour
    • Perfect first- and inter-layer adhesion
    • Can be printed at high printing speeds
  • Create wood-nerve structures
    • By postprocessing the printed object with a piece of fine grit sandpaper
    • By varying with the print/extrusion temperature
  • Biodegradable

General printing guidelines*

Nozzle size:≥ 0.4mm

Layer height:≥ 0.2mm

Flow rate:± 104%

Print temp:± 210 - 240 C

Print speed:Low

Retraction:Yes ± 5mm

Heat bed:± 0 - 60 C

Fan speed:50-100%

Experience level:Beginner

*) Above displayed settings are meant as guidance to find your optimal print settings. These ranges in settings should work for most printers, but please do feel free to experiment outside these ranges if you think it is suitable for your printer. There are a lot of different type of printers, hot-ends and printer offsets that it is extremely difficult to give an overall one-size-fits-all setting.

Filament length

: 1.20 g/cc

50 gr coil

0.5 Kg spool

2.3 Kg spool

Ø 1.75mm

± 17.3m

± 173m

797m

Ø 2.85mm

± 6.5m

± 65m

300m

Nozzle cleaning

When printing with filled/composite filaments it is recommended to clean your nozzle immediately after printing by feeding 15-20cm PLA filament through your nozzle. This will make sure that any potential fillers are flown out of your nozzle. It is even better to use glow in the dark PLA as the extremely hard phosphorous particles are much more likely to scrape out residual waste from your nozzle.

Product export information

HS Code:39169090

Description:Monofilament

Country of origin:the Netherlands

Compliance*

This filament is compliant to below listed directives and regulations.

  • RoHS directive 2011/65/EC
  • REACH directive 1907/2006/EC

*) This declaration of conformity to directives and regulations is prepared according to our present standard of knowledge and may be amended if new cognitions are available and applies only for the above described products.

SKU V177-175EWOOD-BIRCH-0050
Brand Does not apply
Shipping Height 1.500m
Shipping Length 19.000m
Shipping Cubic 0.060000000m3

Others Also Bought